Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Manuale Utente Scaricare il pdf (Pagina 10)

CommLink IV Technical Guide

Operator Interface

Finding What COM Port Number the

CommLink IV is Using

1. Left-click on <Start>, located on the bottom left of the

Windows Tool Bar.

2. Select <Control Panel>.

3. Double-click the System Icon.

4. Click the <Hardware> tab.

5. Click the <Device Manager> button.

6. Click on the plus sign next to Ports to see all of the common

ports.

7. Locate the USB Serial Port (COM#). The COM# in pa-

rentheses is the port it is located on. Write this COM port

number down. You will need to know this when setting up

the Prism software.

8. If the COM port number is 10 or greater, go to “Chang-

ing the USB COM Port Number” in the Troubleshooting

section on page 18; otherwise, continue with the section

“Prism Setup” on page 11 or “Prism II Setup” on page 12.

Finding the COM Port Number

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Nessun commento

Auto-zone-control-systems CommLink IV Technical Guide, Installation Instruct Manuale Utente Pagina 10