Auto-zone-control-systems Auto-Zone CV-C Controller Installation Guide (Vers Manuale Utente Scaricare il pdf (Pagina 24)

Section 2

Auto-Zone CV-C

2-14 Sequence of Operation

below the cooling setpoint by the same amount it rose above it to start the

demand.

c. Once the cooling demand has been satisfied, the valve will go fully closed

until the next cooling demand or until the Humidity requires the valve to

open.

Once the Chilled Water Valve is enabled for operation, the actual valve position is

calculated using a Proportional, Integral and Derivative (PID) formula. All three formula

constants are user adjustable along with a fourth setpoint for the Integrating Interval.

There are defaults programmed in the code that should not be changed unless the user,

through actual observation, has determined that the valve is hunting or is not operating

quickly enough to maintain a constant Supply Air Temperature.

A later section entitled PID Operation can be refereed to for an actual example of code

that does the valve positioning. This formula applies to both Chilled Water and Hot

Water Valve operations.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

Nessun commento

Auto-zone-control-systems Auto-Zone CV-C Controller Installation Guide (Vers Manuale Utente Pagina 24